Pointing Devices and Displays

Pointing Devices and Displays

Reply
Contributor
fmichaelsikes
Posts: 11
Registered: ‎06-26-2008
Message 1 of 4 (889 Views)

CROSSHAIRS "JUMPING"

889 Views, 3 Replies
06-22-2010 09:40 AM

DOES ANYONE KNOW HOW TO ADJUST THE CROSSHAIR MOVEMENT

SO IT IS SMOOTH INSTEAD OF JUMPING?

Contributor
maximo916
Posts: 20
Registered: ‎03-05-2009
Message 2 of 4 (872 Views)

Re: CROSSHAIRS "JUMPING"

07-14-2010 09:01 AM in reply to: fmichaelsikes

Turn SNAP off.

In the command prompt....SNAP>Enter>OFF

 

I've found that anytime I do DVIEW, Snap turns itself on. Not sure why.

Active Contributor
rmitchler
Posts: 33
Registered: ‎01-08-2008
Message 3 of 4 (655 Views)

Re: CROSSHAIRS "JUMPING"

12-16-2010 02:21 PM in reply to: fmichaelsikes

To add to that turn your grid off it also causes the jump between grid spacing.

 

Robert

New Member
texankevin
Posts: 1
Registered: ‎12-08-2010
Message 4 of 4 (471 Views)

Re: CROSSHAIRS "JUMPING"

03-14-2011 12:52 PM in reply to: fmichaelsikes
check your grid snaps, you can turn them off or change to snap size. Really unless you are working with Architechure you dont really even need to use grid snaps. good luck
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.