PLM 360 General Discussion

PLM 360 General Discussion

Reply
Product Support
JohnCHill
Posts: 352
Registered: ‎03-27-2012
Message 1 of 2 (288 Views)
Accepted Solution

How to Copy and Paste a Workflow

288 Views, 1 Replies
05-15-2012 06:30 AM

Do you have a Workflow that you would like to reuse in a new Workspace?



John Hill
Support Specialist
Product Support
Autodesk, Inc.

Here is how you can Copy and Paste that Workflow saving you valuable time.

 

  1. Open the Workflow Editor and load the Workspace to copy from
  2. Use Ctrl A to select all
  3. Use Control C to copy the selection
  4. In the Workflow  Editor, click File and then choose Reload Workspaces
  5. Load the target Workspace with the empty Workflow
  6. Use Ctrl V to paste in the copied Workflow Map
  7. Click File and choose Upload
  8. You can then close the Workflow Editor as there is no need to save changes to the original Workflow Map
Product Support
JohnCHill
Posts: 352
Registered: ‎03-27-2012
Message 2 of 2 (286 Views)

Re: How to Copy and Paste a Workflow

05-15-2012 06:35 AM in reply to: JohnCHill

Here is how you can Copy and Paste that Workflow saving you valuable time.

 

  1. Open the Workflow Editor and load the Workspace to copy from
  2. Use Ctrl A to select all
  3. Use Control C to copy the selection
  4. In the Workflow  Editor, click File and then choose Reload Workspaces
  5. Load the target Workspace with the empty Workflow
  6. Use Ctrl V to paste in the copied Workflow Map
  7. Click File and choose Upload
  8. You can then close the Workflow Editor as there is no need to save changes to the original Workflow Map


John Hill
Support Specialist
Product Support
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post