PLM 360 General Discussion

PLM 360 General Discussion

Reply
Product Support
JohnCHill
Posts: 352
Registered: ‎03-27-2012
Message 1 of 2 (110 Views)
Accepted Solution

Are the total number of Tabs in a Workspace available to configure fixed?

110 Views, 1 Replies
06-12-2012 07:12 AM

Are the total number of Tabs in a Workspace available to configure fixed?



John Hill
Support Specialist
Product Support
Autodesk, Inc.

Yes, the total number of Tabs is fixed and is always available in each workspace.  You can decrease the number of tabs that are viewed within a record through setting permissions and configuring roles.  In certain cases, like the Change Log, even if the tab isn’t active via the permissions, the changes are still being logged in case you wish to enable this at a later time.

Product Support
JohnCHill
Posts: 352
Registered: ‎03-27-2012
Message 2 of 2 (109 Views)

Re: Are the total number of tabs in a workspace available to configure fixed?

06-12-2012 07:13 AM in reply to: JohnCHill

Yes, the total number of Tabs is fixed and is always available in each workspace.  You can decrease the number of tabs that are viewed within a record through setting permissions and configuring roles.  In certain cases, like the Change Log, even if the tab isn’t active via the permissions, the changes are still being logged in case you wish to enable this at a later time.



John Hill
Support Specialist
Product Support
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post