.NET
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Running Native AutoCAD Commands

4 REPLIES 4
SOLVED
Reply
Message 1 of 5
vince1327
612 Views, 4 Replies

Running Native AutoCAD Commands

Hey Everyone,

 

So this is something i've been wondering about for a while now but haven't had enough of an application to justify trying to figure it out. At this point however, i've designed a small conversion form that can be called by our engineers and allow them to convert between various units. I'd like to have a button though that allows them to call up the Quick Calc application from within AutoCAD. What i'm wondering is how do i actually call a native autoCAD command? Is it possible and if so where could i find documentation on the syntax. For what it's worth i'm working in C# in VS 2010.

 

As always any help is greatly appreciated.

Cheers!

4 REPLIES 4
Message 2 of 5
GTVic
in reply to: vince1327

There are lots of topics on this, search this discussion group for "command" or "command line" or "commandline"

Message 3 of 5
vince1327
in reply to: vince1327

Not to be a pain, but i can't seem to find anything in relatino to what i'm asking about.

Message 4 of 5
GTVic
in reply to: vince1327
Message 5 of 5
vince1327
in reply to: vince1327

Thanks, after a bit of googling i was able to get the SendStringToExecute working.

 

Cheers

Vince

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk DevCon in Munich May 28-29th


Autodesk Design & Make Report

”Boost