.NET

Reply
Active Contributor
RasmusB
Posts: 35
Registered: ‎04-12-2012
Message 1 of 3 (256 Views)
Accepted Solution

Problem with Application.DocumentManager.Open?

256 Views, 2 Replies
10-16-2013 03:54 AM

After having copied objects (3d faces) from working database to a side database, I open the dwg through the above mentioned method. However, then when I right-click in the drawing (and all other drawings that are open) the last command is repeated although according to the right-click customization settings in OPTIONS, ACAD is supposed to show the short cut menu in all "modes" (Edit, Command etc).

 

If I don't open the drawing programmatically, but use the GUI instead, then the right-click menu appears on right click (as expected).

---
2B or not 2B? That is the question! The answer is FF.

Try switching NEXTFIBERWORLD. 

Active Contributor
RasmusB
Posts: 35
Registered: ‎04-12-2012
Message 2 of 3 (246 Views)

Re: Problem with Application.DocumentManager.Open?

10-16-2013 06:14 AM in reply to: RasmusB

If I go into Right-click customization and choose to always enable Shortcut Menu in Command Mode (instead of only when command options are present), then the right-click menu appears each time I right click...If I check the CMDACTIVE variable, it tells me that an ordinary command is active (1), and according to CMDNAMES this is the SETVAR (but this is always the case?).

---
2B or not 2B? That is the question! The answer is FF.
Contributor ow
Contributor
ow
Posts: 18
Registered: ‎01-17-2009
Message 3 of 3 (185 Views)

Re: Problem with Application.DocumentManager.Open?

10-21-2013 05:04 AM in reply to: RasmusB

Try switching NEXTFIBERWORLD. 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.