.NET

Reply
Valued Contributor
ProfWolfMan
Posts: 86
Registered: ‎04-21-2010
Message 1 of 3 (450 Views)
Accepted Solution

Non-Uniformly scaled block

450 Views, 2 Replies
06-15-2011 01:04 AM

Hi all,


In one of my application i do exploding some blocks.

Now i got some non-uniformly scaled blocks from user.

 

Inside the block there is no 3dsolid or unexplodable objects.
Always it has different scale on Z scale only.(for example x=0.5,y=0.5,z=1.0)


Is there is any method to explode this block?

Otherwise to reset the z scale factor?


Please share.


Thanks & Regards,
G

Cant you just set the scale factors to be the same as x or y?

 

bref.ScaleFactors = new Scale3d(bref.ScaleFactors.X,bref.ScaleFactors.X,bref.ScaleFactors.X);

 

Active Contributor
jamierobertson1
Posts: 39
Registered: ‎04-11-2004
Message 2 of 3 (445 Views)

Re: Non-Uniformly scaled block

06-15-2011 01:45 AM in reply to: ProfWolfMan

Cant you just set the scale factors to be the same as x or y?

 

bref.ScaleFactors = new Scale3d(bref.ScaleFactors.X,bref.ScaleFactors.X,bref.ScaleFactors.X);

 

Mentor
MarkPendergraft
Posts: 375
Registered: ‎06-27-2005
Message 3 of 3 (419 Views)

Re: Non-Uniformly scaled block

06-15-2011 11:48 AM in reply to: ProfWolfMan

Do you have elevated lines/text/etc inside the block?  Is the block at a different elevation then the linework inside it?  What are you planning on doing with the block?

 

If the z scale doesn't factor in, then yeah just leave it at 1 or do what the previous poster said and change it to match the x or y component.

 

-Mark

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.