Distinguished Contributor
Posts: 136
Registered: ‎07-24-2009
Message 1 of 3 (141 Views)

Linetype - How to catch errors

141 Views, 2 Replies
02-08-2012 10:35 AM

When I load the linetype file


'' Load the Center Linetype
acCurDb.LoadLineTypeFile(sLineTypeName, gstrc_SFR_LineType_FullFileName)


How do I detect if the linetype is in the Linetype file? How do I do my error checking here in the ACAD way? 


Currently I just search the acad.lin or sfr.lin Text File to see if the LineType Exists. This works.


But I was curious how would you check the linetype file via the Acad API,

to see if the linetype definition name exists in the file? 







*Expert Elite*
Posts: 5,380
Registered: ‎10-12-2006
Message 2 of 3 (124 Views)

Re: Linetype - How to catch errors

02-08-2012 03:00 PM in reply to: VB_Autocad_guy

Try/catch, resorting to the CONTINUOUS linetype hard-coded into AutoCAD in the event an error is thrown.

If you are going to fly by the seat of your pants, expect friction burns.
Adopt. Adapt. Overcome. Or be overcome.
A good question will be halfway to a good answer.

Valued Contributor
Posts: 95
Registered: ‎11-15-2011
Message 3 of 3 (113 Views)

Re: Linetype - How to catch errors

02-09-2012 07:47 AM in reply to: VB_Autocad_guy

or, with reference to the example from the developers guide, open the linetypetable and check whether linetypetable.has(linetype). in addition to reverting to any particular linetype - which may be perfectly fine - you can check for alternative linetypes and/or load a particular linetype file.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.