*Nate Hunter
Message 1 of 2 (152 Views)

Insert annotative block

152 Views, 1 Replies
06-26-2007 05:26 AM
I am tyring to insert a block and make it annotative. Below is what I am
using. ssSymInsertPnt is the insertion point of the block, strTag is the
block path and name, ssRotate is the rotation of the block. For whatever
reason when I insert using this method the block does not become annotative.
When I manually insert the block using AutoCAD's insert command the block is
annotative. Any Ideas what I am doing wrong.

InsertBlk = ThisDrawing.ModelSpace.InsertBlock(ssSymInsertPnt, strTag,
96.0#, 96.0#, 96.0#, CDbl(ssRotate))
Distinguished Contributor
Posts: 172
Registered: ‎11-19-2003
Message 2 of 2 (152 Views)

Re: Insert annotative block

06-27-2007 08:55 AM in reply to: *Nate Hunter
Look at this post
Maybe it will help you. There are much more posts there but i think this is
the one for you.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.