Posts: 4
Registered: ‎06-02-2009
Message 1 of 2 (180 Views)
Accepted Solution

Help with "CreateExtrudedSolid" & "sweepoptions "

180 Views, 1 Replies
04-18-2013 04:28 PM

In the past I used "AddExtrudedSolid" to extrude a region without any problems, worked like a charm see "old" code below.


F3D = AcadDoc.ModelSpace.AddExtrudedSolid(AcadRegion, Math.Abs(CollThickness(x)), 0)


I'm currently updating the code because "AddExtrudedSolid" is now known as "CreateExtrudedSolid". In the new version, my last parameter is asking for a "sweepoptions". Doesn't matter what I put there, it doesn't like it. See the code below. What do I need to do to make it work?


Dim so As SweepOptions
F3D = acSol3D.CreateExtrudedSolid(AcadRegion, Math.Abs(CollThickness(x)), so )


*Expert Elite*
Posts: 1,569
Registered: ‎10-08-2008
Message 2 of 2 (159 Views)

Re: Help with "CreateExtrudedSolid" & "sweepoptions "

04-18-2013 10:23 PM in reply to: wcruzcc
Try this code snip it's working on A2010:
sold.CreateExtrudedSolid(curv, New Vector3d(1, 2, 20), New SweepOptions())
Change vector and curve to your settings
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.