.NET

Reply
Valued Contributor
mindofcat
Posts: 55
Registered: ‎05-14-2012
Message 1 of 4 (264 Views)
Accepted Solution

Extend an Arc?

264 Views, 3 Replies
05-15-2013 09:58 AM

Hi All,

 

I'd like to express my appreciation for all the help I've gotten on this forum since I started this journey of converting existing VBA code into VB.NET.

 

I am almost done with my project, but I just encountered another problem, which has me really stumped...

 

I have an arc and a line, and I'd like to extend the endpoint of the arc so that it meets the startpoint of the line (image attached in this post). I've tried every which way I could think of, and the results are never what I wish to accomplish.

 

I searched this forum, and found a likely solution where the CircularArc3D object is being utilized, but unfortunately, this solution utilizes the Curve object's IntersectWith method, and this method crashes my code on a 32-bit system running AutoCAD 2010.

 

In my code, I also tried arc.EndPoint=line.StartPoint but when I execute, I get a NotImplementedException error in AutoCAD 2010.

 

Any pointers or suggestions?

 

Many thanks in advance...

Problem solved. I tried fillet, and it created the necessary arc to replace the one I needed to extend.

 

Thanks for the fillet insight...

 

 

Active Contributor
R.Gerritsen4967
Posts: 47
Registered: ‎07-31-2009
Message 2 of 4 (221 Views)

Re: Extend an Arc?

05-16-2013 02:09 AM in reply to: mindofcat

Maybe this is of some help?

how to fillet line and arc?

Valued Contributor
mindofcat
Posts: 55
Registered: ‎05-14-2012
Message 3 of 4 (206 Views)

Re: Extend an Arc?

05-16-2013 08:27 AM in reply to: R.Gerritsen4967

Thanks for the reply. But I've already been through that post before, and realized it wouldn't solve my problems; I'm not using command line to do my fillet.

 

However, you just gave me an insight as to what I can try; I can see if filleting will solve this problem. Lemme give it a try...

Valued Contributor
mindofcat
Posts: 55
Registered: ‎05-14-2012
Message 4 of 4 (201 Views)

Re: Extend an Arc?

05-16-2013 10:13 AM in reply to: mindofcat

Problem solved. I tried fillet, and it created the necessary arc to replace the one I needed to extend.

 

Thanks for the fillet insight...

 

 

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.