.NET

Reply
Distinguished Contributor
junoj
Posts: 116
Registered: ‎02-26-2009
Message 1 of 3 (227 Views)
Accepted Solution

Construction Geometry and bulge

227 Views, 2 Replies
09-09-2013 12:44 AM

I would like to create a construction geometry that would behave as the Polyline Bulge. In other worlds I would like to create a Construction Arc that would have a Bulge. Upon examination, I was not able to locate any of the Construction Geometry that has a bulge.

 

The purpose of this is to determine the Bulge location (direction) of the polyline I am creating.

 

I would like to stay away from creating a database geometry, if possible -  please advice.

 

Thank you,

 

-J

Hi,

 

Look at the Autodesk.Geometry.Circulararc2d class. It provides a constructor with the arc Bulge.

*Expert Elite*
_gile
Posts: 2,106
Registered: ‎04-29-2006
Message 2 of 3 (205 Views)

Re : Construction Geometry and bulge

09-09-2013 11:42 AM in reply to: junoj

Hi,

 

Look at the Autodesk.Geometry.Circulararc2d class. It provides a constructor with the arc Bulge.

Gilles Chanteau
Distinguished Contributor
junoj
Posts: 116
Registered: ‎02-26-2009
Message 3 of 3 (183 Views)

Re : Construction Geometry and bulge

09-10-2013 10:06 PM in reply to: _gile

Thank you Gilles.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.