.NET

Reply
Distinguished Contributor
junoj
Posts: 116
Registered: ‎02-26-2009
Message 1 of 3 (220 Views)
Accepted Solution

Construction Geometry and bulge

220 Views, 2 Replies
09-09-2013 12:44 AM

I would like to create a construction geometry that would behave as the Polyline Bulge. In other worlds I would like to create a Construction Arc that would have a Bulge. Upon examination, I was not able to locate any of the Construction Geometry that has a bulge.

 

The purpose of this is to determine the Bulge location (direction) of the polyline I am creating.

 

I would like to stay away from creating a database geometry, if possible -  please advice.

 

Thank you,

 

-J

Hi,

 

Look at the Autodesk.Geometry.Circulararc2d class. It provides a constructor with the arc Bulge.

*Expert Elite*
_gile
Posts: 2,087
Registered: ‎04-29-2006
Message 2 of 3 (198 Views)

Re : Construction Geometry and bulge

09-09-2013 11:42 AM in reply to: junoj

Hi,

 

Look at the Autodesk.Geometry.Circulararc2d class. It provides a constructor with the arc Bulge.

Gilles Chanteau
Distinguished Contributor
junoj
Posts: 116
Registered: ‎02-26-2009
Message 3 of 3 (176 Views)

Re : Construction Geometry and bulge

09-10-2013 10:06 PM in reply to: _gile

Thank you Gilles.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.