.NET

Reply
Contributor
osayed3202
Posts: 12
Registered: ‎01-05-2014
Message 1 of 3 (223 Views)
Accepted Solution

Autocad 2014 processor error message

223 Views, 2 Replies
01-15-2014 01:57 AM

 

dear guys,

please i was working in the project and the assebliy was loading on Autocad 2014 without any problems but i tried to open it today I found this message below and the processor choosen as image attached is 'Any' and the attched text file shows the message when i am loading the assebly.

so i am struggling whts going on 

 

 

"Warning 2 There was a mismatch between the processor architecture of the project being built "MSIL" and the processor architecture of the reference "accoremgd", "AMD64". This mismatch may cause runtime failures. Please consider changing the targeted processor architecture of your project through the Configuration Manager so as to align the processor architectures between your project and references, or take a dependency on references with a processor architecture that matches the targeted processor architecture of your project. ZFP-XrefBind-2014"

 

and also for the other references.

Best Regards
O.Sayed
CAD developer
HI ,
you can take a look in below link where same Problem has been discussed.

http://forums.autodesk.com/t5/NET/Mismatch-Processor-AMD64-vs-MSIL/td-p/3796563
Mentor
mzakiralam
Posts: 231
Registered: ‎11-09-2012
Message 2 of 3 (204 Views)

Re: Autocad 2014 processor error message

01-15-2014 04:43 AM in reply to: osayed3202
HI ,
you can take a look in below link where same Problem has been discussed.

http://forums.autodesk.com/t5/NET/Mismatch-Processor-AMD64-vs-MSIL/td-p/3796563
Contributor
osayed3202
Posts: 12
Registered: ‎01-05-2014
Message 3 of 3 (149 Views)

Re: Autocad 2014 processor error message

01-20-2014 07:40 AM in reply to: mzakiralam
thank you very much I changed the processor to be 64bit
Best Regards
O.Sayed
CAD developer
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!