.NET

Reply
*Expert Elite*
Sinc
Posts: 6,207
Registered: ‎11-18-2006
Message 11 of 13 (149 Views)

Re: Associative MLeader using .NET

07-07-2008 07:22 PM in reply to: *Gagan Gajabaharia
Well, as an interesting data point, if I try to run Kean's code in Civil-3D 2008, I get the same results that he does. It's only when I try to run it in Civil-3D 2009 that the leaders only come out the left side.
Sinc
*Expert Elite*
Sinc
Posts: 6,207
Registered: ‎11-18-2006
Message 12 of 13 (149 Views)

Re: Associative MLeader using .NET

07-08-2008 05:20 AM in reply to: *Gagan Gajabaharia
Sure enough, Kean had the answer.

The MLeader works differently in the 2009 series of products. Include this line as the last step, after creating the MLeader and just before committing the transaction:

mld.MoveMLeader(new Vector3d(), MoveType.MoveAllPoints);

Since it uses a 0 vector, this doesn't actually move the MLeader, but it forces the geometry to be recalculated.
Sinc
Active Contributor
todavew91
Posts: 27
Registered: ‎03-30-2006
Message 13 of 13 (149 Views)

Re: Associative MLeader using .NET

07-08-2008 05:22 AM in reply to: *Gagan Gajabaharia
Good to hear the resolution.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.