.NET

Reply
New Member
JoKees
Posts: 1
Registered: ‎08-26-2005
Message 1 of 2 (60 Views)

Adding references and auto completion

60 Views, 1 Replies
08-26-2005 08:27 AM
Hi all,

I'm just getting started in .net programming. So I followed the CAD Clinic Going.NET article to get myself a little bit more familiar with this programming thing and #Develop.
As the author explained I referenced both AcdbMgd.dll and AcMgd.dll (from the .NET Assembly browser).

So far, no problem, but fact is that there is no 'auto completion' for both the DLL's (for others there is no problem).

Does anyone run in the same problem, and how can you fix it.
It is quite difficult to program without.

PS. The auto completion table was already created

Thanks
*Mike Tuersley
Message 2 of 2 (60 Views)

Re: Adding references and auto completion

08-26-2005 09:36 AM in reply to: JoKees
There is no auto completion with #Develop - it has something to do with the
Adesk libraries. Check the #Develop news groups as they were looking into
it a while back.

Even without the auto-completion, its still good for a free ide ;-)

-- Mike
___________________________
Mike Tuersley
___________________________
the trick is to realize that there is no spoon...
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.