Quantification re-setup possible?

[nic.maes]

Hi,

I have a Navisworks project where i setup the quantification in Metric units in Meters.
I would like to change that to Millimeter.

Also, can i set the decimal place for the values in the Quantification?

3 digit places for millimeter values is a little to much?

Best regards

[scott.a.green]

 Hello!, 

To change the display units: 

1. Click Application Button > Options.

2. In the options editor, expand Interface > Display Units.   

3. Select the units you want from the Linear Units dropdown.

Does this help?

[nic.maes]

Hi,
Thanks for the reply.
You can change the general display units,
I want to change the units for the quantification.
Apparently this is different from the display units.

I think once set you can not change the quantification units.

Best regards,
Nic Maes

[scott.a.green · Accepted solution]

From testing Navisworks out on my end with Takeoff, it doesn't appear that this is possible without reloading the project from before you set up quantification-takeoff and then setting it up again with the correct unit values.