Navisworks General Discussion

Navisworks General Discussion

Reply
Contributor
hardell
Posts: 19
Registered: ‎09-21-2012
Message 1 of 1 (543 Views)

plant 3d pipe insulation in nw2013

543 Views, 0 Replies
02-08-2013 06:09 AM

Hi,

I have some problems with insulation in nw2013. I can use nwcout commant in p3d and load the nwc-file. The insulation shows up fine. However, when using the normal way and load a dwg direcly into NW, the insulation doesn´t show up.

 

I have read some previous discussions regfarding this. Do anyone know if Autodesk has fixed this issue to 2013 version? Is there any good description on the matter?

 

 

Best regards

//Johan

Announcements
Have API Questions?
New Dedicated Forum for Navisworks API

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.