Navisworks General Discussion

Navisworks General Discussion

Reply
Contributor
cparvez
Posts: 11
Registered: ‎06-08-2009
Message 1 of 2 (258 Views)

Object Settings?

258 Views, 1 Replies
08-11-2010 07:47 AM

I've got a NAVIS file but when I try to navigate thru it, if I run into conduit, duct work, or any objects in the model, it stops me cold.  Is there a command or setting that allows me to pass thru the objects like I normally do?

Contributor
cparvez
Posts: 11
Registered: ‎06-08-2009
Message 2 of 2 (256 Views)

Re: Object Settings?

08-11-2010 08:54 AM in reply to: cparvez

found it... Viewpoint tab > motion settings panel > realism drop-down>uncheck (or check) the collision check box  or cntrl + D for short

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.

Announcements
Have API Questions?
New Dedicated Forum for Navisworks API