Navisworks General Discussion

Reply
Contributor
cparvez
Posts: 11
Registered: ‎06-08-2009
Message 1 of 2 (257 Views)

Object Settings?

257 Views, 1 Replies
08-11-2010 07:47 AM

I've got a NAVIS file but when I try to navigate thru it, if I run into conduit, duct work, or any objects in the model, it stops me cold.  Is there a command or setting that allows me to pass thru the objects like I normally do?

Contributor
cparvez
Posts: 11
Registered: ‎06-08-2009
Message 2 of 2 (255 Views)

Re: Object Settings?

08-11-2010 08:54 AM in reply to: cparvez

found it... Viewpoint tab > motion settings panel > realism drop-down>uncheck (or check) the collision check box  or cntrl + D for short

Announcements
Have API Questions?
New Dedicated Forum for Navisworks API

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.