Navisworks General Discussion

Navisworks General Discussion

Reply
Active Member
MustangSam
Posts: 8
Registered: ‎07-22-2011
Message 1 of 2 (175 Views)

Navisworks Freedom feedback

175 Views, 1 Replies
10-29-2012 05:59 AM

Hi all, your opinions please.

 I work in a design office, I am trying to set up navisworks as a useful tool for the company, in the design office we have licences for Simulate, which in turn we would throw the NWD files out to the supervisors to use with freedom, however I am discovering that freedom wont let you save viewpoints, wont let you make comments etc, that supervisors can make, and we can then pick up in the office and act on accordingly.

 

Has anyone set up navisworks in a similar way and created an effective dialogue back and fore?

or has anyone side-stepped this problem in any other way?

Any suggestions would be very gratefully recieved,

thanks

 

Sam

*Expert Elite*
dgorsman
Posts: 5,277
Registered: ‎10-12-2006
Message 2 of 2 (166 Views)

Re: Navisworks Freedom feedback

10-29-2012 07:41 AM in reply to: MustangSam

A lot of our seniors are... well, seniors :smileyhappy:  They do things "old school" with red/green/blue pencils and yellow highlighter.  They use Freedom to look around and inspect, then mark things up on drawings.  In some cases they might take screen shots, print them, and mark those up.  So before you get too strung out, see if they would actually be *using* those features.

----------------------------------
If you are going to fly by the seat of your pants, expect friction burns.
Adopt. Adapt. Overcome. Or be overcome.
A good question will be halfway to a good answer.


Announcements
Have API Questions?
New Dedicated Forum for Navisworks API

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.