Navisworks General Discussion

Navisworks General Discussion

Reply
Member
Rcole
Posts: 3
Registered: ‎04-24-2012
Message 1 of 2 (449 Views)

Navisworks 2013 Corrupt Error

449 Views, 1 Replies
12-21-2012 01:42 PM

I receive the following error upon opening a NWF file.

 

Navisworks Error.jpg

 I am able to save the NWF but am unable to save or export a .nwd file and receive the following error.

Navisworks Error2.jpg

 

Any ideas on what is wrong?

Employee
JeffH_ADSK
Posts: 149
Registered: ‎10-29-2009
Message 2 of 2 (369 Views)

Re: Navisworks 2013 Corrupt Error

01-11-2013 04:56 AM in reply to: Rcole

The first error message means that Navisworks attempted to read in a given block of geometry from the file and that block failed to validate (most likely from an NWD). The second error message is a knock-on effect. We can't save out a new file with corrupt data, as we'd be saving out a corrupt file. The existing NWF can be saved because the specific block that is corrupt isn't saved into the NWF (it comes from a file that the NWF is referencing, and the NWF would still successfully save that reference).

 

Is drive N mapped to a network location? Do you get the same error if you try the same full set of files from your local hard disk?

 

There is a possibility that opening/saving over a network can yield corruption in translating the file between local memory & a remote location. We've had cases where opening & saving NWDs transfers the data in a different manner vs just copying the file & in that case the data can be corrupted during the network transfer by the time it reaches the local PC.

 

Hope that helps,

 

Jeff



Senior Software Engineer
Navisworks
Autodesk Ltd.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Have API Questions?
New Dedicated Forum for Navisworks API