Navisworks General Discussion

Reply
Valued Contributor
rnbhat
Posts: 95
Registered: ‎09-10-2009
Message 1 of 1 (299 Views)

Exporting an Elipse to Navisworks

299 Views, 0 Replies
09-10-2009 04:18 AM
Hi,

We have a problem exporting an ellipse to Navisworks. We have experienced that if we export a whole ellipse (i.e. without any breaks in it ) it is exported to Naviswork but if we export an ellipse which is split by half it dose not show any thing in the Naviswork navigator.

Please see an attached "Ellipse.zip" containing an image for reference; above in the image we have the Naviswork navigator & below we see the ellipse in the ADT 2007.
Also attached is the ADT file (2007 version) containing the two Ellipse.

If any one has a solution or if we are wrong any where, please correct us.
Any help will be appreciated.
Regards,
Raghavendra Bhat
rnbhat1@gmail.com
Announcements
Have API Questions?
New Dedicated Forum for Navisworks API

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.