Community
Navisworks Forum
Welcome to Autodesk’s Navisworks Forums. Share your knowledge, ask questions, and explore popular Navisworks topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Clash RL is incorrect

1 REPLY 1
Reply
Message 1 of 2
nicholas.rostin
294 Views, 1 Reply

Clash RL is incorrect

I'm using NW to check clearances to under ground serivces.

 

I have a surface triangulation and clashing with 3d objects (in my case 3d tubes) representing the service.

Water, Tele comms, Gas, Sewer etc.

 

Using the 'clearance' clash option.

 

My problem is in the reporting, Navis provides a Northing and Easting of the service, which are 100% correct.

However the RL (Z value) of the clash point seems to split the difference between the surface triangulation and the 3d tube.

 

ie assume surface triangulation is flat and RL is 2 metres, service is 1m below the triangulation.  If I run a 'clearance' clash on this data it tells me the 'clash point' is at RL 1.5m.

 

I will note that the 'Distance' output in the report is correct. It would output 1m in this example.

 

Can someone please recommed a solution?

 

1 REPLY 1
Message 2 of 2

I am not clear on what you are expecting to happen.

Also, if you can attach a small sample NWD file, with the clearance test setup, that could help to determine if what you are seeing is expected behavior.



Lance Coffey

Technical Support Specialist

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report