Mechanical Desktop

Reply
New Member
jclark
Posts: 1
Registered: ‎10-12-2006
Message 1 of 3 (1,414 Views)

Node & Line Visibility

1414 Views, 2 Replies
08-20-2012 01:08 PM

Hello:

 

Can anyone direct me to post that may have solved my problem, or give me some guidence.

I'm currently using MDT 2009, and XP Pro. I've created my model and have added nodes and lines to the model. In paper space I've dimensioned to the nodes in my model, suddenly the nodes disappear in model space. The dimensions in paper space are still there but the nodes are not visible in model space. I have tech support with my subscription, but MDT 2009 is no longer supported. Stephen Bessette at Autodesk was kind enough to suggest a "Clean Purge", I did this procedure twice but the nodes and lines still do not appear in my model. Does anyone have any suggeestions?

 

Thanks

Jclark

*Pro
ampster
Posts: 1,277
Registered: ‎07-26-2005
Message 2 of 3 (1,412 Views)

Re: Node & Line Visibility

08-20-2012 01:22 PM in reply to: jclark

just a guess, is there a pdmode variable in MDT?

 

In reg Acad, I've adjusted pdmode to equal 3 in order to see points/nodes at times.  Not sure if that's available in MDT or not.

Active Member
Jamie-Lyn
Posts: 9
Registered: ‎10-30-2013
Message 3 of 3 (425 Views)

Re: Node & Line Visibility

11-20-2013 05:41 PM in reply to: ampster

On the command line "ddptype" brings up a dialogue box

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.