After being a injection mold designer for 20 yrs and using MDT 3.0 since '98, I've had to upgrade to MDT 2006. Can't get over how it's improved (I can extrude splines now) and as soon as I get it "tweaked in" I'm sure it'll be just as fast and adroit as it was. However, I'm at a loss to figure out the CUI aspect as my install has no help files (much to my chagrin). I already had to re-install once due to the known bug about the cui files (forget what the error message was but others have noted it) and I'm a bit gun-shy to customize now. Obviously i need to educate myself about this new feature lest I run into error yet a second time. Can anyone point me in the right direction as to where I might find some documentation or tutorials on this? I've tried working (blindly) with the "transfer" feature with bad results; won't try that again. Any input would be helpful,
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.