Inventor Publisher

Inventor Publisher

Reply
Active Contributor
VictorBDEngineer
Posts: 46
Registered: ‎10-19-2010
Message 1 of 3 (132 Views)

Unable to remove extra leaders on callout.

132 Views, 2 Replies
06-17-2012 10:33 PM

How do you remove an extra leader that has been added to a callout apart from deleting the cutout and starting again.

 

Regards

Victor Pringle

Employee
TimeraAutodesk
Posts: 150
Registered: ‎02-03-2012
Message 2 of 3 (128 Views)

Re: Unable to remove extra leaders on callout.

06-18-2012 10:04 AM in reply to: VictorBDEngineer

Hi Victor,

 

You are correct here - currently there is no workflow for removing additional leaders from callouts other than deleting the callout and re-creating it. Do you find yourself in need of this function often in your workflow?

 

Thanks,

Timera

Active Contributor
VictorBDEngineer
Posts: 46
Registered: ‎10-19-2010
Message 3 of 3 (126 Views)

Re: Unable to remove extra leaders on callout.

06-18-2012 10:25 AM in reply to: TimeraAutodesk

I do not normally have to remove leaders but this one occasion I had got over enthusastic and added one extra after adding 10 others. It was a small inconvience to delete the call out and start again.

 

Regards

Victor

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.