I am getting the following when I try to save certain models:
Shortly after the program crashes and I lose my work.
I am also getting the same message, more or less, when I try to open some files, but only some of the time.
Going through the same issue again with another file that I just updated. Can not proceed with any changes with the prospect of not being able to save the file .Hoping a solution for this happens soon! As projects are starting to stop in regard to very issue.
We are now working hard to find solution for this issue. If you meet such problem, could you please send an email to Huan.Yu@autodesk.com ? If you can share with us your file and the file is small to email, please attach it in your email. If the file is too big to email, we will reply to your email with instructions of how to send the big file to us for investigation.
Thank you for helping us resolve the issue.
Autodesk Inventor Publisher Team
Crashing is all my 2012 and 2013 Inventor Publisher does. I just spent 4 hours on an exploded view only to see my work disappear when I get the "Inventor Publisher has unexpectantly closed..." error screen. I always send my dump files and never hear of any answers. Is there a way to recover the file I was working on when Inventor Publisher 2013 crashed this evening around 8 pm?
Thank you for the feedback. We received your error report and looked into it. But we can not find much info from the report to help us solve the problem. Could you please send your both good and bad IPB files to Huan.Yu@autodesk.com? It would also be helpful if you can let us know the steps you did to crash Publisher?
Thank you for your support!
Inventor Publisher QA
I have gotten your dataset, but can't reproduce the crash issue.Below are my steps:
Environment: Win 7 64bit, memory 8G, desktop computer. Version Publisher 2013 RTM
1, Open the ipb in publisher, move the component (007143363.ipt)and move another component which in the red circle in the picture which you marked.
2, save document
Result: not crash.
1, Create a new document, import the SAT file
2, move the component which you marked in the red circle
3 save the docment
Result: not crash
Could you give me more information about the your workflow? So that i can reproduce it and pass this issue to the development team.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!