Inventor Publisher

Inventor Publisher

Active Contributor
Posts: 51
Registered: ‎06-04-2012
Message 1 of 2 (198 Views)

Publisher Vault Check in Problem

198 Views, 1 Replies
11-08-2013 06:17 AM


When I open a Publisher file from Vault I always get a question if I want to check out the file.
And when I want to edit the publisher file I check it out of course.

But when I finish with editing the file and about to save and close Publisher. I get the question if I want to check in the file in Vault again, which I do, but then I get a message that its all ready a file in Vault with that name...
Yes of course it is the file I'm just about to check in?
How do I work around this problem?


See attach file.


BR Timmy

Posts: 233
Registered: ‎03-02-2011
Message 2 of 2 (171 Views)

Re: Publisher Vault Check in Problem

11-14-2013 01:08 AM in reply to: timmy.stalnacke

I find Vault frustrating to use.


I had your problem amongst others and I haven't solved it, but I do have a sort of workaround.


Basically I never do any Vault work in Publisher. Check-out from Vault and Check-in in Vault. I only ever save the file in Publisher. I've not had any problems since adopting this approach.


Also, make sure you save your files on your C: drive in the same place that you have the folder set-up in Vault, if that makes sense.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.