Inventor Publisher

Reply
Active Contributor
rich-s
Posts: 40
Registered: ‎03-29-2007
Message 1 of 2 (116 Views)

Publish Area Setup

116 Views, 1 Replies
03-02-2012 06:38 AM

I'm almost done with my storyboard and I've published to image .png for review. I've noticed my image quality is not the best and I'm missing some of the nuts & bolts. I updated the Publish Area on one of the snapsnhots to a custom print size of 15in x 15in and increased the resolution from 72 to 300. My image is much better and I want to do this for the entire storyboard. I selected all the snapshots, set it to affect all in storyboard, edited the publish area setup. However it did not update any other snapshots, just the one I was on. Is the publish area adjustable only in each snapshot or did i miss a step to update them all at one time?

Active Contributor
fsanchou
Posts: 63
Registered: ‎04-01-2010
Message 2 of 2 (110 Views)

Re : Publish Area Setup

03-02-2012 01:43 PM in reply to: rich-s

As a workaround, select all the snapshots, then change the setting of the publish area to pixel size 1080x1080, click OK. All snapshots are resolved at this resolution.


Then return to the publish area set and set a custom print size of 15 "x15" and 300 dpi. All snapshots are resolved at this new resolution.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.