Inventor Publisher

Reply
Member
TonGalina
Posts: 5
Registered: ‎12-11-2013
Message 1 of 2 (214 Views)

Isometric views as standard?

214 Views, 1 Replies
12-15-2013 05:57 AM

I hope there are standard views like IsoMetric views in Publisher???
If yes, how can find these?

Valued Mentor
coreyparks
Posts: 488
Registered: ‎06-07-2010
Message 2 of 2 (194 Views)

Re: Isometric views as standard?

12-16-2013 06:13 AM in reply to: TonGalina

The only thing you can use is the viewcube in the upper right after you have the model inserted.  The way this handles views leaves a lot to be desired, especially when it comes to zooming in and out.

Please mark this response "Accept as solution" if it answers your question.
-------------------------------------------------------------------------------------
Corey Parks
IV2014 Factory Design Suite Ultimate
Windows 7 64 bit
Synergis Adept document management software
16gb RAM --- Nvidia Quadro 4000 2gb
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.