I am able to open existing .ipb files and work with them normally, however, whenever I try to bring in an Inventor assembly or part, I get a hang up and eventual crash.
I have Inventor 2012 and 2013 installed and this happens with either format used in Inventor Publisher 2013.
I have Serice Pack 1 installed as well as when I installed the software I had UAC turned off. I have run an Reinstall through the Control Panel and this has not solved the issue either. How am I supposed to use this if I can't get an Inventor file into the storyboard?!?!?
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Mark Flayler - Engagement Engineer
IMAGINiT Manufacturing Solutions Blog: https://resources.imaginit.com/manufacturing-solutions-blog
Hello Mark,
Are you experiencing this issue after you updated to Service pack 1?
Rajkumar Ilanchelian
Autodesk Fusion
Join Fusion Insider
Yes.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Mark Flayler - Engagement Engineer
IMAGINiT Manufacturing Solutions Blog: https://resources.imaginit.com/manufacturing-solutions-blog
Mark,
I tried importing a few Inventor assembly files and did not have any issues. Would it be possible to pack and go a small file that you are having this issue and email it to rajkumar.ilannchelian@autodesk.com? If the file size is larger than 10MB please email me and I will send you a dropbox share to upload the file.
Rajkumar Ilanchelian
Autodesk Fusion
Join Fusion Insider
To be honest, its not a file issue, it happens on all files no matter their creation. I did find a workaround in that if I already have an IPB open and then start a new document I am able to import, I just can't do it from scratch without already haveing something open. This seems like a bug to me or a bad installer. I sincerely doubt you can help me with getting a file set (it even happens on the Publisher sample data sets and courseware files).
About the only way you could assist at this point may be a remote desktop and inspect the issue and perhaps the installer files.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Mark Flayler - Engagement Engineer
IMAGINiT Manufacturing Solutions Blog: https://resources.imaginit.com/manufacturing-solutions-blog
Driver Issue. Installed new Video driver for my Quadro FX880 and it works fine now.
Thank you for your help though.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Mark Flayler - Engagement Engineer
IMAGINiT Manufacturing Solutions Blog: https://resources.imaginit.com/manufacturing-solutions-blog
Thanks for the update. Glad to hear that it is a non-issue.
Rajkumar Ilanchelian
Autodesk Fusion
Join Fusion Insider