Inventor Publisher

Reply
Distinguished Mentor
pcrawley
Posts: 695
Registered: ‎05-23-2002
Message 1 of 1 (151 Views)

Facets "flashing" in mobile output.

151 Views, 0 Replies
01-16-2011 12:21 PM

I have a building draw in AutoCAD - it's just a simple polyface mesh.  If I output that to DWF and then insert that into Inventor Publisher, the resulting mobile output shows half of every face with its normals flipped.  It's not consistant flipping - but as you zoom in and out on the mobile devide, these facets flash and flicker - to the point where it's un-usable.  It looks like every pane of glass in the facade is broken.

 

I know the model units in AutoCAD are big numbers (50 floors - milimeters - drawn 1:1) but even after scaling is down 1000 times it's no better.  Maybe I'm barking up the wrong tree here?  Any suggestions for making the mobile output better?  I'll post a sample in a minute.

Peter
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.