Inventor Publisher

Reply
New Member
bweis96
Posts: 1
Registered: ‎03-08-2012
Message 1 of 4 (156 Views)

driving constraints?

156 Views, 3 Replies
03-08-2012 12:40 PM

I am on a robotics team and we have a scissor lift on our bot.  How would you go about animating the lifting of the scissor lift?  It is the movement of about 100 parts and i cant figure out how to do it.  Can you drive constraints in Publisher?  Thanks! Ben

Valued Mentor
AlexF1980
Posts: 315
Registered: ‎07-05-2005
Message 2 of 4 (146 Views)

Re: driving constraints?

03-13-2012 04:04 AM in reply to: bweis96

Hi,

 

This is a total stab in the dark, but you might be able to animate between positional representations defined within your Inventor Model.

 

If Publisher can't do this, then someone should add it to the "Wish List" for enhancements..

 

:-)

Employee
TimeraAutodesk
Posts: 150
Registered: ‎02-03-2012
Message 3 of 4 (135 Views)

Re: driving constraints?

03-15-2012 02:28 PM in reply to: AlexF1980

Hi All-

 

Constraints are not supported in Publisher currently, but thanks for bringing it to our attention as a wish-list item.

 

Thanks,

 

TImera Hart

Autodesk

Mentor
bowen192
Posts: 231
Registered: ‎03-02-2011
Message 4 of 4 (125 Views)

Re: driving constraints?

03-20-2012 04:16 AM in reply to: TimeraAutodesk

TimeraAutodesk wrote:

Hi All-

 

Constraints are not supported in Publisher currently, but thanks for bringing it to our attention as a wish-list item.

 

Thanks,

 

TImera Hart

Autodesk


If I could pick just one thing to change in Publisher, it would be the support of constraints. Top of my wish list, no question about that.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.