Inventor Publisher

Inventor Publisher

Reply
Active Contributor
CadlineSupport
Posts: 48
Registered: ‎02-23-2012
Message 1 of 5 (948 Views)
Accepted Solution

Callouts balloons and detail views losing attachment

948 Views, 4 Replies
08-21-2012 01:35 AM

Hi,

Publisher 2013 SP2 I am getting callouts, balloons and detail views losing their reference on the part and pinging off away from the model when I hit save or export an image or video. It doesn't happen all the time, its ok when the components haven't been moved much, but if I have anything more than a simple unidirectional explode the issue is very prevalent. This is quite a serious glitch are there any workarounds or workflows you would recommend, and is this likely to be fixed in SP3?

Many thanks

I think i have find a way to solve the problem!

If i always choose parents (the green square) when i place the callouts, even that just is a part or from content center.

works for me right now.

Active Contributor
timmy.stalnacke
Posts: 45
Registered: ‎06-04-2012
Message 2 of 5 (946 Views)

Re: Callouts balloons and detail views losing attachment

08-21-2012 01:48 AM in reply to: CadlineSupport

I have the same problem! some times the will get back in place after saving, sometime they don't.
Really frustrating.

Active Contributor
timmy.stalnacke
Posts: 45
Registered: ‎06-04-2012
Message 3 of 5 (928 Views)

Re: Callouts balloons and detail views losing attachment

08-22-2012 07:30 AM in reply to: CadlineSupport

I think i have find a way to solve the problem!

If i always choose parents (the green square) when i place the callouts, even that just is a part or from content center.

works for me right now.

Active Contributor
CadlineSupport
Posts: 48
Registered: ‎02-23-2012
Message 4 of 5 (924 Views)

Re: Callouts balloons and detail views losing attachment

08-22-2012 08:01 AM in reply to: timmy.stalnacke

Hi Timmy,

That seems to work! Even if you actually select the same part, just using the 'parents' option. Outstanding work - thanks for this.

Active Contributor
timmy.stalnacke
Posts: 45
Registered: ‎06-04-2012
Message 5 of 5 (726 Views)

Re: Callouts balloons and detail views losing attachment

10-10-2012 07:28 AM in reply to: CadlineSupport

the problem i gone in SP3

 

Best regards 

Timmy

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.