Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
mrattray
Posts: 2,507
Registered: ‎09-13-2011
Message 11 of 12 (889 Views)

Re: Yet another annoying message

12-13-2012 10:36 AM in reply to: jletcher

"iLogicVb.UpdateWhenDone = True" sets a flag that tells Inventor to update when it's done. It doesn't matter where it goes because it wont act on it until it's finished running everything anyways.

If I had used "InventorVb.DocumentUpdate()", then you would be correct, because this line causes Inventor to stop and update immediately.

 

Mike (not Matt) Rattray

*Pro
jletcher
Posts: 1,975
Registered: ‎05-18-2011
Message 12 of 12 (879 Views)

Re: Yet another annoying message

12-13-2012 10:48 AM in reply to: mrattray

Yeah I did know the rule just thought it reads from top to bottom no matter what unless you tell it to go back to it..

 

I did program a long time ago so things have changed a bit and I have not been following.

 

I am now into it and learning Curtis has helped me out so much I feel I owe him dinner lol...


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.