Wish List Item-Change views to broken views

[Anonymous]

Ability to change an existing base or projected view to a Broken view would
be incredible valuable.

Modeling is done first & many times we design parts or assemblies not
knowing (or being concerned with) how they are going to fit the sheets.

Many times the parts change or there is a new version that is bigger & the
designer has to Redo the views as broken. It would be great to have the
ability to just put a break where needed into an existing non-broken view.

What do you all think about this?

[Anonymous]

Ummm... that IS how you create a broken view - from an existing view.

"Gary Cross" wrote in message
news:362FC81598313A575E84DA135E2B7AA9@in.WebX.maYIadrTaRb...
> Ability to change an existing base or projected view to a Broken view
would
> be incredible valuable.
>
> Modeling is done first & many times we design parts or assemblies not
> knowing (or being concerned with) how they are going to fit the sheets.
>
> Many times the parts change or there is a new version that is bigger & the
> designer has to Redo the views as broken. It would be great to have the
> ability to just put a break where needed into an existing non-broken view.
>
> What do you all think about this?
>
>

[Anonymous]

Sorry...was meant for MDT group. I've been switching back & forth from MDT &
am getting punchy. I suspect we are not going to see any improvements in MDT
so it may just be a lost cause.