Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
Karol-Or
Posts: 265
Registered: ‎11-28-2011
Message 1 of 4 (195 Views)
Accepted Solution

Where is the select mode?

195 Views, 3 Replies
07-11-2013 09:27 AM

I want to change the selection method to feature priority.

Where is the button?

Not in the right click


Karol-Or wrote:

Not in the right click


Try Shift + right click (while not in any command, also try while in another command).

 

Too slow Chris - did you eat your Wheaties?

*Expert Elite*
Curtis_Waguespack
Posts: 3,002
Registered: ‎03-08-2006
Message 2 of 4 (191 Views)

Re: Where is the select mode?

07-11-2013 09:38 AM in reply to: Karol-Or

Hi Karol-Or,

 

It might vary depending on the version you using and the file type/ environment you're in, but look on the Quick Acess toobar along the top of the screen.

 

Autodesk Inventor Selection Filter.png

 

If you don't see this, then it might be helpful to provide more details on your version and the file type/ environment you're working in.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





*Expert Elite*
JDMather
Posts: 28,246
Registered: ‎04-20-2006
Message 3 of 4 (182 Views)

Re: Where is the select mode?

07-11-2013 09:44 AM in reply to: Karol-Or

Karol-Or wrote:

Not in the right click


Try Shift + right click (while not in any command, also try while in another command).

 

Too slow Chris - did you eat your Wheaties?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
cbenner
Posts: 3,421
Registered: ‎04-06-2010
Message 4 of 4 (179 Views)

Re: Where is the select mode?

07-11-2013 09:45 AM in reply to: Curtis_Waguespack

Shift / Right Click... assuming you are in part or assembly mode.

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cadtipstricks.wordpress.com//


   

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.