Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
Karol-Or
Posts: 265
Registered: ‎11-28-2011
Message 1 of 4 (188 Views)
Accepted Solution

Where is the select mode?

188 Views, 3 Replies
07-11-2013 09:27 AM

I want to change the selection method to feature priority.

Where is the button?

Not in the right click


Karol-Or wrote:

Not in the right click


Try Shift + right click (while not in any command, also try while in another command).

 

Too slow Chris - did you eat your Wheaties?

*Expert Elite*
Curtis_Waguespack
Posts: 2,934
Registered: ‎03-08-2006
Message 2 of 4 (184 Views)

Re: Where is the select mode?

07-11-2013 09:38 AM in reply to: Karol-Or

Hi Karol-Or,

 

It might vary depending on the version you using and the file type/ environment you're in, but look on the Quick Acess toobar along the top of the screen.

 

Autodesk Inventor Selection Filter.png

 

If you don't see this, then it might be helpful to provide more details on your version and the file type/ environment you're working in.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





*Expert Elite*
JDMather
Posts: 27,020
Registered: ‎04-20-2006
Message 3 of 4 (175 Views)

Re: Where is the select mode?

07-11-2013 09:44 AM in reply to: Karol-Or

Karol-Or wrote:

Not in the right click


Try Shift + right click (while not in any command, also try while in another command).

 

Too slow Chris - did you eat your Wheaties?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
cbenner
Posts: 3,287
Registered: ‎04-06-2010
Message 4 of 4 (172 Views)

Re: Where is the select mode?

07-11-2013 09:45 AM in reply to: Curtis_Waguespack

Shift / Right Click... assuming you are in part or assembly mode.

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cbennertipstricks.blogspot.com/


   

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.