Inventor General Discussion

Inventor General Discussion

Reply
Active Member
ryansmalley
Posts: 10
Registered: ‎08-07-2011
Message 1 of 5 (708 Views)

When I create a simulation the stress analysis ribbon doesn't enable options.

708 Views, 4 Replies
08-07-2011 04:03 PM

What do I need to do to enable the stress analysis buttons? Please answer with screen shots if possible, it would help to see where to click and what to do. Thanks

I am using  Autodesk Inventor 2012 proffesional.

*Expert Elite*
JDMather
Posts: 27,610
Registered: ‎04-20-2006
Message 2 of 5 (703 Views)

Re: When I create a simulation the stress analysis ribbon doesn't enable options

08-07-2011 05:15 PM in reply to: ryansmalley

Show a screen shot of your Environments tab.
Sown a screen shot of your Tools>Addins

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
ryansmalley
Posts: 10
Registered: ‎08-07-2011
Message 3 of 5 (667 Views)

Re: When I create a simulation the stress analysis ribbon doesn't enable options

08-18-2011 04:51 PM in reply to: JDMather

Here are the screen shots, please help.

*Expert Elite*
JDMather
Posts: 27,610
Registered: ‎04-20-2006
Message 4 of 5 (652 Views)

Re: When I create a simulation the stress analysis ribbon doesn't enable options

08-19-2011 05:14 AM in reply to: ryansmalley

Have you gone through the getting started tutorials for using the Ribbon Interface?
It appears you have set to Compact rather than Normal (see attached image).
Right click on a tab and set Ribbon Appearance to Normal.

Or is something else your problem?

 

Why does it take 11 days to post requested information?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
ryansmalley
Posts: 10
Registered: ‎08-07-2011
Message 5 of 5 (633 Views)

Re: When I create a simulation the stress analysis ribbon doesn't enable options

08-19-2011 01:00 PM in reply to: JDMather

The problem is when I mouse over the buttons the menu underneath is grayed out. Like when I mouse over the loads button everything underneath is grayed out and I cannot click on anything.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.