Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I click on the status tab and Inventor crashes. Has anyone else run into
this problem or found a solution? I have asked this before with no solution,
Just accidentally pressed the tab again putting info in and lost it, BANG!
or was it Swoosh?
Jerry
Tough one. I have never had that happen here.
Jerry Chasek wrote:
> I click on the status tab and Inventor crashes. Has anyone else run into
> this problem or found a solution? I have asked this before with no solution,
> Just accidentally pressed the tab again putting info in and lost it, BANG!
> or was it Swoosh?
> Jerry
>
>
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")