Inventor General Discussion

Reply
Distinguished Contributor
Closterman
Posts: 144
Registered: ‎12-02-2003
Message 1 of 3 (31 Views)

Welments, no array??

31 Views, 2 Replies
11-11-2002 10:30 PM
In a weldments, on the machining section, I can't do an array! Why? How do you do a bolt circle? I don't want to use the array in the sketch because when I put the bolt I cant use the "feature pattern selection". I'v just begun to use INV6 and the part I work is migrated from INV5.3
Another thing, when I put tolerence in the model, the tolerence don't follow in the drawing?? I hope it's not normal !!! By the way, i'm happy, in two days I only have 2 power exit ;-) It's not so bad...
Closterman
*Riddle, Rich
Message 2 of 3 (31 Views)

Re: Welments, no array??

11-11-2002 10:57 PM in reply to: Closterman
It would be nice to be able to revolve. I'm not
sure when I would use this but it would be nice


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
In
a weldments, on the machining section, I can't do an array! Why? How do you do
a bolt circle? I don't want to use the array in the sketch because when I put
the bolt I cant use the "feature pattern selection". I'v just begun to use
INV6 and the part I work is migrated from INV5.3
Another thing, when I put
tolerence in the model, the tolerence don't follow in the drawing?? I hope
it's not normal !!! By the way, i'm happy, in two days I only have 2 power
exit ;-) It's not so bad...
Closterman
Contributor
jdsmith
Posts: 13
Registered: ‎11-28-2003
Message 3 of 3 (31 Views)

Re:

11-16-2002 12:32 PM in reply to: Closterman
feature patterns at the assembly level may be available
in a future release but not this one. try your model
tolerance to the idw after SP1. JDS
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.