Inventor General Discussion

Reply
*Expert Elite*
blair
Posts: 4,152
Registered: ‎11-13-2006
Message 11 of 13 (212 Views)

Re: Weldment

10-28-2010 08:59 AM in reply to: ijc

You will probably have to do a Split-Face on the riser pipe. This will give a funny result at the points on the riser pipe.

 

Your Split-Face line will start at the end-point of the cope of the Riser pipe.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Distinguished Contributor ijc
Distinguished Contributor
ijc
Posts: 150
Registered: ‎07-03-2010
Message 12 of 13 (196 Views)

Re: Weldment

10-28-2010 02:18 PM in reply to: blair

Thanks Blair...IJC

New Member
eih5
Posts: 1
Registered: ‎05-28-2011
Message 13 of 13 (75 Views)

Re: Weldment

11-17-2012 04:52 PM in reply to: ijc

Hi,

Did you ever figure this out?

I am dealing with exactly the same problem, putting weldments on two pipes of same diameter.  I tried to use Split-Face but couln't get this to work. Help would be very much appreciated.

 

Einar

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.