Inventor General Discussion

Inventor General Discussion

*Expert Elite*
Posts: 4,494
Registered: ‎11-13-2006
Message 11 of 13 (215 Views)

Re: Weldment

10-28-2010 08:59 AM in reply to: ijc

You will probably have to do a Split-Face on the riser pipe. This will give a funny result at the points on the riser pipe.


Your Split-Face line will start at the end-point of the cope of the Riser pipe.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / / 4.17
Delta Tau Chi ΔΤΧ
Distinguished Contributor ijc
Distinguished Contributor
Posts: 155
Registered: ‎07-03-2010
Message 12 of 13 (199 Views)

Re: Weldment

10-28-2010 02:18 PM in reply to: blair

Thanks Blair...IJC

New Member
Posts: 1
Registered: ‎05-28-2011
Message 13 of 13 (78 Views)

Re: Weldment

11-17-2012 04:52 PM in reply to: ijc


Did you ever figure this out?

I am dealing with exactly the same problem, putting weldments on two pipes of same diameter.  I tried to use Split-Face but couln't get this to work. Help would be very much appreciated.



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.