Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
blair
Posts: 4,494
Registered: ‎11-13-2006
Message 11 of 13 (216 Views)

Re: Weldment

10-28-2010 08:59 AM in reply to: ijc

You will probably have to do a Split-Face on the riser pipe. This will give a funny result at the points on the riser pipe.

 

Your Split-Face line will start at the end-point of the cope of the Riser pipe.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
Distinguished Contributor ijc
Distinguished Contributor
ijc
Posts: 155
Registered: ‎07-03-2010
Message 12 of 13 (200 Views)

Re: Weldment

10-28-2010 02:18 PM in reply to: blair

Thanks Blair...IJC

New Member
eih5
Posts: 1
Registered: ‎05-28-2011
Message 13 of 13 (79 Views)

Re: Weldment

11-17-2012 04:52 PM in reply to: ijc

Hi,

Did you ever figure this out?

I am dealing with exactly the same problem, putting weldments on two pipes of same diameter.  I tried to use Split-Face but couln't get this to work. Help would be very much appreciated.

 

Einar

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.