Inventor General Discussion

Inventor General Discussion

Reply
Active Member
8 Posts
1 Kudo
Registered: ‎08-24-2012
Post 11 of 11

Re: Weld Fill Visibility

10-09-2012 07:26 AM in reply to: mpascoe

I don't think that is the issue I'm encountering. I'm seeing this issue in a drawing of a top-level assembly. The assembly does contain sub-assemblies, but the welds that are not showing up properly do not involve any of the subassemblies. They are welds between different bodies of a multi-body part and welds between one of those bodies and content center components (a flange in this case). Thanks for replying though!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post