Inventor General Discussion

Reply
Active Contributor
sam__gleeson
Posts: 46
Registered: ‎10-11-2012
Message 1 of 4 (218 Views)

volume

218 Views, 3 Replies
12-19-2012 04:51 AM

Hi

 

How can i work out the internal volume of the cylinder attached

 

Thanks

 

Sam

*Expert Elite*
JDMather
Posts: 26,624
Registered: ‎04-20-2006
Message 2 of 4 (196 Views)

Re: volume

12-19-2012 09:05 AM in reply to: sam__gleeson

Drag red End of Part marker back above Delete Face to get back to original.  (see attached)

another technique is to Derive Component the original so that you can have both conditions at the same time.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Contributor
sam__gleeson
Posts: 46
Registered: ‎10-11-2012
Message 3 of 4 (183 Views)

Re: volume

12-19-2012 10:50 AM in reply to: sam__gleeson

than you JD Mather

 

1.  where can i then view the volume inside this cylinder.Is there a dialogue box in the tabs which gives the volume inside such as how many litres this cylinder will hold

 

2.  Could you please post a example of Derive Component the original so that you can have both conditions at the same time..another technique for me to learn

 

Thanks for help

 

Sam

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

t

 

*Expert Elite*
JDMather
Posts: 26,624
Registered: ‎04-20-2006
Message 4 of 4 (163 Views)

Re: volume

12-19-2012 02:22 PM in reply to: sam__gleeson

Check iProperties for the volume.

See attached for Derived Component method.

 

Right click on the top node of the browser to find iProperties.

iProperties.PNG

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.