Inventor General Discussion

Reply
Valued Contributor
sam__gleeson
Posts: 53
Registered: ‎10-11-2012
Message 1 of 4 (229 Views)

volume

229 Views, 3 Replies
12-19-2012 04:51 AM

Hi

 

How can i work out the internal volume of the cylinder attached

 

Thanks

 

Sam

*Expert Elite*
JDMather
Posts: 27,603
Registered: ‎04-20-2006
Message 2 of 4 (207 Views)

Re: volume

12-19-2012 09:05 AM in reply to: sam__gleeson

Drag red End of Part marker back above Delete Face to get back to original.  (see attached)

another technique is to Derive Component the original so that you can have both conditions at the same time.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Valued Contributor
sam__gleeson
Posts: 53
Registered: ‎10-11-2012
Message 3 of 4 (194 Views)

Re: volume

12-19-2012 10:50 AM in reply to: sam__gleeson

than you JD Mather

 

1.  where can i then view the volume inside this cylinder.Is there a dialogue box in the tabs which gives the volume inside such as how many litres this cylinder will hold

 

2.  Could you please post a example of Derive Component the original so that you can have both conditions at the same time..another technique for me to learn

 

Thanks for help

 

Sam

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

t

 

*Expert Elite*
JDMather
Posts: 27,603
Registered: ‎04-20-2006
Message 4 of 4 (174 Views)

Re: volume

12-19-2012 02:22 PM in reply to: sam__gleeson

Check iProperties for the volume.

See attached for Derived Component method.

 

Right click on the top node of the browser to find iProperties.

iProperties.PNG

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.