Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
eleblanc
Posts: 122
Registered: ‎10-30-2006
Message 1 of 4 (134 Views)

visibility of spline end (square)

134 Views, 3 Replies
12-06-2012 11:25 AM

Is there a way to disable visibility of spline end squares, in a sketch?

 

 

*Expert Elite*
JDMather
Posts: 27,512
Registered: ‎04-20-2006
Message 2 of 4 (133 Views)

Re: visibility of spline end (square)

12-06-2012 11:31 AM in reply to: eleblanc

Not sure why you would want to do this, but

Tools>Application Options>General Tab and set Annotation scale to 0.2

 

You could also toggle the points to centermarks.

 

This image is with Annotation Scale at 0.7 and shown both with Points or CenterPoints.

 

Spline Points.PNG

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Distinguished Contributor
eleblanc
Posts: 122
Registered: ‎10-30-2006
Message 3 of 4 (99 Views)

Re: visibility of spline end (square)

12-13-2012 02:05 PM in reply to: JDMather

Can't find "set annotation" on the general tab.

*Expert Elite*
JDMather
Posts: 27,512
Registered: ‎04-20-2006
Message 4 of 4 (92 Views)

Re: visibility of spline end (square)

12-14-2012 04:53 AM in reply to: eleblanc

What version of Inventor are you using?

Annotation Scale.png

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.