Inventor General Discussion

Inventor General Discussion

Reply
Mentor
TONELLAL
Posts: 162
Registered: ‎01-17-2010
Message 1 of 2 (150 Views)

Views background update never ends

150 Views, 1 Replies
11-06-2012 02:14 AM

Hello,

When I open a drawing, Inventor 2012 update views. The default option is Background update". The problem is the update never ends... I can use Inventor, but the background update is ne finished, so I can't print a correct drawing.

If I disable Backupdate it is ok, but how can I use it ?

Distinguished Contributor
obourne
Posts: 171
Registered: ‎03-02-2011
Message 2 of 2 (92 Views)

Re: Views background update never ends

06-21-2013 01:32 PM in reply to: TONELLAL

Hi,

I had the same issue and was able to resolve it by doing the following:

 

1) In Application Options>Drawing tab I uncheck background updates.

2) In drawing document I opened it with defer updates.

3) Navigated to page with the issue.

4) IN Doc Settings I uncheck defer updates AND changed memory saving mode pull down to NEVER.

 

After the drawing finished updating the issue was gone.

 

Hope it works for you too.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.