Inventor General Discussion

Reply
New Member
Bobeep
Posts: 2
Registered: ‎05-04-2012
Message 1 of 4 (175 Views)
Accepted Solution

View updates

175 Views, 3 Replies
05-04-2012 05:08 AM

Hallo there.

 

Is there a way to stop my drawing views from updating when I make a change to my assembly? I have assemblys of boxes that I need to make different views from but everytime I open the door to show an inside view it screws up my other views.

 

Regards

Bobeep

I think you need to do some reading about view representations.

*Expert Elite*
mrattray
Posts: 2,515
Registered: ‎09-13-2011
Message 2 of 4 (173 Views)

Re: View updates

05-04-2012 05:13 AM in reply to: Bobeep

I think you need to do some reading about view representations.

Mike (not Matt) Rattray

*Expert Elite*
jtylerbc
Posts: 890
Registered: ‎09-01-2010
Message 3 of 4 (163 Views)

Re: View updates

05-04-2012 06:32 AM in reply to: mrattray

And depending on whether you're actually opening (moving) the door or just turning its visibility off to visually remove it, you might also want to look at positional representations.

John Tyler
Inventor 2015
Windows 7 64 Bit
Employee
johnsonshiue
Posts: 2,288
Registered: ‎04-30-2008
Message 4 of 4 (151 Views)

Re: View updates

05-04-2012 01:21 PM in reply to: Bobeep

I am sorry that I may not fully understand your workflow here. But, it sounds like you might have created some drawing views from upper level assembly when all you need is the views of the subassembly. Would creating subassembly view help here? Could you attach an image here or an assembly showing the problem you have?

Thanks!

 



Johnson Shiue (johnson.shiue@autodesk.com)
Senior Principal SQA Engineer, Inventor
Mechanical Design
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!